ER5356
Class: ER5356
AWS: A5.10
Conforms to Certification: AWS A5.10 | ASME SFA A5.10
Weld Process: Mig (GMAW)
| AWS Chemical Composition Requirements | |
| Si = 0.25 max | Zn = 0.10 max |
| Fe = 0.40 max | Ti = 0.06 – 0.20 |
| Cu = 0.10 max | Cr = 0.05 – 0.20 |
| Mn = 0.05 – 0.20 | Al = Remainder |
| Mg = 4.5 – 5.5 | Be = 0.0003 max |
| Other = 0.05 each – 0.15 total | |
| Available Sizes | |||
| .030x 1#spool | .035x 1#spool | 3/64x 1#spool | 1/16x 16#spool |
| .030x 16#spool | .035x 16#spool | 3/64x 16#spool | 1/16x 20#spool |
| 3/64x 20#spool | |||
Application
ER5356 materials are used mainly for welding aluminum of like composition. This type is also useful if color match is important after anodizing.
- The proper choice of aluminum filler metal mainly depends on the base metal properties to be achieved andwelding technique. Post weld cracking, corrosion resistance and behavior under elevated temperature also needto be taken into consideration.
- Cracking usually can be minimized by choosing a filler metal alloy of higher alloy content then the base metal.
Deposited Chemical Composition % (Typical)
Deposited chemistry is influenced by many factors so no typical analysis can be reported.
Deposited All Weld Metal Properties %
As-Welded
Deposited all weld metal properties are influenced by many factors such as weld process used, so no typical weld metal properties can be reported.
Deposited Charpy-V-Notch Impact Properties %
Not applicable