ER5183
Class: ER5183
AWS: A5.10
Conforms to Certification: AWS A5.10 | ASME SFA A5.10
Weld Process: Mig, Electron bead, Oxyfuel Gas welding
| AWS Chemical Composition Requirements | |
| Si = 0.40 max | Cr = 0.05 – 0.25 |
| Fe = 0.40 max | Zn = 0.25 max |
| Cu = 0.10 max | Ti = 0.15 max |
| Mn = 0.50 – 1.0 | Al = Remainder |
| Mg = 4.3 – 5.2 | Be = 0.0003 max |
| Other = 0.05 each – 0.15 total | |
Available Sizes:
Upon Request, call for more information
Application
ER5183 can be used on type base materials 5083 and 5456. Not recommended for sustained elevated temperature service. Assure proper storage to avoid contamination.
- The proper choice of aluminum filler metal mainly depends on the base metal properties to be achieved andwelding technique. Post weld cracking, corrosion resistance and behavior under elevated temperature also needto be taken into consideration.
- Cracking usually can be minimized by choosing a filler metal alloy of higher alloy content then the base metal.
Deposited Chemical Composition % (Typical)
Deposited chemistry is influenced by many factors so no typical analysis can be reported.
Deposited All Weld Metal Properties %
As-Welded
Deposited all weld metal properties are influenced by many factors such as weld process used, so no typical weld metal properties can be reported.
Deposited Charpy-V-Notch Impact Properties %
Not applicable
Recommended Operation of Welding Rods
Weld parameters are dependent upon the actual weld process being utilized.